My Rendition of T-Chisels Blanket Chest. Chapter 5

  • Advertise with us
Blog entry by FlWoodRat posted 02-01-2009 12:14 PM 892 reads 0 times favorited 1 comment Add to Favorites Watch

While waiting for the glue to dry on my panel stock, I made a ‘panel raising’ jig for my table saw. Then after trimming the panel stock to width and height, I ran them through my TS. Eight panels raised and 10 fingers remain. The jig worked well. WOOHOO.

Set-Up and Test Flight of my Jig.

Here are one end panel and one front/back panel

And here is the edge detail._

Weather permitting I will dry fit the panels in the frame today.

Have a safe day in your shop.

-- I love the smell of sawdust in the morning....

1 comment so far

View Scott Bryan's profile

Scott Bryan

27250 posts in 3788 days

#1 posted 02-01-2009 02:58 PM

Nice job on the panels. They look clean and the corners are well defined. I don’t blame you a bit for being excited about the success of your jig. I am looking forward to the next chapter.

-- Challenges are what make life interesting; overcoming them is what makes life meaningful- Joshua Marine

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics