Hydraulic Crane (Toys and Joys) #3: Mistake in drawing 2

  • Advertise with us
Blog entry by Dutchy posted 08-16-2015 12:37 PM 1333 reads 0 times favorited 3 comments Add to Favorites Watch
« Part 2: Mistake in drawing 1 Part 3 of Hydraulic Crane (Toys and Joys) series Part 4: Mistake in drawing 3 »

I Have to admit that my english is bad but also fractional measurement is hard for me to do. So I hope my calculations in the below picture are correct

Thanks for watching.

-- My englisch is bad but how is your dutch?

3 comments so far

View johnstoneb's profile


2384 posts in 1781 days

#1 posted 08-16-2015 01:34 PM

I picked up an inexpensive digital caliper that reads in fractions, decimal and metric. It makes it easy to convert just put in the the fraction then push the button to the reading type you want. sure beat the hell out of a pencil and paper or finding a calculator.

-- Bruce, Boise, ID

View Dutchy's profile


2156 posts in 1777 days

#2 posted 08-16-2015 02:11 PM

My solution to the fractional/mm problem:

-- My englisch is bad but how is your dutch?

View stefang's profile


15512 posts in 2942 days

#3 posted 08-16-2015 03:04 PM

Both good. Some of my tools have the conversions printed on the back of them.

-- Mike, an American living in Norway.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics