LumberJocks

shop re start the new RMR #4: stop water penetration and band saw breakdown

  • Advertise with us
Blog entry by DsRMR posted 04-13-2017 08:58 AM 1443 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 3: hesitant progress Part 4 of shop re start the new RMR series no next part

Hello again it’s been slow going in the shop still been darn cold out plus had some water control to get under control. This was the result of poor workmanship of the pole barn that is my shop atm. The perimeter of the buildings ground work was above the bottom of the cur-agate siding, with nothing sealing the outside moisture out. I dug down about 4 inches below the siding, pulled the lower row of screws out and layed 6 mil plastic down tucking it under the siding then replaced the screws. from the inside i then filled each opening in the siding with expanding foam sealant and wala its dry inside now.. I have been also scavenging some materials to close up the open 2 bays of the shop. the far side is framed and has some used osb sheathing on it the middle bay will be closed up with a set of barn style doors. have been able to work in shop a little bit. still figuring out the best lay out for work ability.

the break down of the bandsaw has begun. need to locate backup bearingshttp://s1302.photobucket.com/user/dgiacchino69/slideshow/new%20shop/bandsaw

-- say not I can not but I Can



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com