LumberJocks

Table Saw Outfeed Table #2: Finished up and tested

  • Advertise with us
Blog entry by Drifter posted 07-30-2012 03:18 PM 1987 reads 4 times favorited 0 comments Add to Favorites Watch
« Part 1: Fabricating the frame Part 2 of Table Saw Outfeed Table series Part 3: Added slots for the miter gauge and a sled. »

Got quite a bit accomplished this weekend. I was able to finish putting the out feed table together saturday morning and then move on to the bathroom vanity again. Sure helps having the outfeed table to handle the larger parts as well as being able to puch through the smaller items without worring about holding on to them on the back side of the saw table.

Here is a little detail on the hinge mounts:

I had to remove the angle iron mount on the side of my saw and enlarge the slots so that I could adjust the height of the outfeed table to match that of the saw bed. Once I had it lined up I skrewed the top down to the frame.

Here is a finished shot – sorry I dont have any pictures of the leg assembly during the build process. I got in the zone and failed to take any pictures until I was done.

And a closeup of the adjustable leg:

Here is the table in the down position:

Once in the down position, both the fence and the miter guage pass over the end without any issue:

-- - It's not worth doing if your not willing to do your best.



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase