LumberJocks

Table Saw Extension / Router Table #3: Working on the top

  • Advertise with us
Blog entry by Dave Rutan posted 09-16-2013 05:25 PM 2482 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 2: The Cuts are Made. Time to Start Gluing. Part 3 of Table Saw Extension / Router Table series Part 4: Starting to take shape »

I’m going to finish the top and install it before installing the drawers. It should be easier that way to get my hands inside, plus I always build the drawers last just in case my ideal measurements were not met.

This wooden piece matches the profile of the edge on the table saw, allowing me to use the rip fence further away from the blade and also use the rip fence to hold my router fence. The piece will be attached on the edge of the router table top.

Here is a better view of the glue up of the top. This shows the lamination of the luan board to my 1/2 inch ply. Since I’m using rough plywood I wanted something nice for the top surface. Another piece of ply gets glued under this to support the router insert. I made all the hand screw clamps shown here. They have served me well.

-- Ni faru ion el ligno!



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com