LumberJocks

CharlesA's Blog

  • Advertise with us
This blog is written by CharlesA | 22 entries so far

Latest Entry

Building Two Baptismal Fonts #2: Learning the three-way half lap joint

08-29-2015 01:54 AM by CharlesA | 0 comments »

One of the key design features of this project is the three-way half lap joint, a joint I learned here on Lumberjocks. I’ve been practicing making them on scrap. After making my 120° sled, I started out on my own. I just tried to figure out the cuts on my own. The result wasn’t terrible, but it was clearly not the best method. So I went back to the thread on LJs and found the youtube video that shopbuilt posted, and I learned the trick to doing this much easier, so thanks to ShopBuilt. Here’s a pick with my first two efforts (after being cut off) and then the last one I did. I did put a little timbermate in the joint to see if I could clean it up just a bit. Fo...

Read this entry »

Older Entries

View all 22 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com