Turns out the next step is making the back rail, clamping it to the glued up sides, and then clamping in a spacer in order to cut out the dovetails for the top, front rail. The back rail was relatively straightforward. I joint with a plane. I...
|View CharlesA's:||home||workshop||projects (7)||blog (20)||reviews (12)||forum topics (73)||buddies (10)||favorites (30)||activity log|
1438 posts in 456 days
Location: Louisville, KY
I'm a hobby woodworker in Louisville, KY. Blessed to have lots of cheap, good hardwood in the area available from local sawmills. I like to make furniture, emphasizing natural look and grain of wood. I work full-time in a quite unrelated field (and travel a fair amount), so I don't churn out many projects.
Looking to learn.
-- "Man is the only animal which devours his own, for I can apply no milder term to the general prey of the rich on the poor." ~Thomas Jefferson
Latest Activity | view all »
|replied on||Gold Standards...||09-22-2014 09:10 PM|
|replied on||Cabinet Table Saw - Which one?||09-21-2014 06:39 PM|
|commented on||Motor burned out in less than 3 days||09-21-2014 02:34 PM|
|replied on||Outfitting a shop - one 'Brand', or best for the application||09-20-2014 07:33 PM|
|replied on||The natural edge forum||09-20-2014 01:33 PM|
|replied on||Where to mount a Power Strip on a Workbench?||09-20-2014 03:20 AM|
|replied on||The natural edge forum||09-20-2014 01:37 AM|
|replied on||The natural edge forum||09-20-2014 01:17 AM|
|replied on||Is this ridiculously dangerous or am I overly cautious?||09-19-2014 08:07 PM|
|commented on||The Masters Slave #1: Making Any Board Straight||09-19-2014 06:24 PM|
|commented on||New Custom Hand Planes||09-19-2014 06:18 PM|
|replied on||Using Danish Oil on Walnut||09-19-2014 04:14 PM|
|replied on||Using Danish Oil on Walnut||09-19-2014 02:26 PM|
|replied on||The natural edge forum||09-19-2014 02:02 PM|
|replied on||The natural edge forum||09-19-2014 01:23 AM|
Latest Projects | view all 7 »
Latest Blog Entries | view all 20 »
This build is going slow because each piece is complicated and because the steps are a bit different than the usual fair. I also ran into some complications with my mortiser bits. But the first step of the build is now done. I marked the morti...
This is my second project progress blog. I am a hobbyist who likes to try to build things beyond my skill set. I started this desk in the spring, then got waylaid by the live edge table I needed to finish. Today I started again. I am making ...
After about 6 coats of Arm-R-Seal (I use gloss for the first few coats because it is easier to deal with, then satin at the end), it’s looking pretty good. I knocked off the rough spots between coats, and thinned it a bit for the last coupl...
I haven’t written an entry for over two weeks, the combination of being on the road (I happen to be among the select few ever to ride in a commercial jet from Montgomery AL to Columbus GA, not that either airport was scheduled in my itinerar...