LumberJocks

The Restoration of a 14" Tenon Saw

  • Advertise with us
Blog series by Brit updated 12-12-2011 06:22 AM 4 parts 21767 reads 66 comments total

Part 1: Identification, Historical Evidence and a Vivid Imagination

10-02-2011 04:36 PM by Brit | 27 comments »

In this blog series, I’d like to invite you to join me on a journey of discovery as we look at the history and restoration of an old English back saw. This is where the story starts… I really wanted one of these (Adria Large Tenon Saw 14”x 4”) …but didn’t have enough of this: So over a number of weeks, I trawled through eBay.co.uk, until I finally found and bought this… The saw plate is 14” long and the saw is 18 ½” overall. It has an iron back and is...

Read this entry »


Part 2: Cleaning the Saw Plate

11-06-2011 11:40 PM by Brit | 14 comments »

This saw plate is remarkably well preserved for its age, but it could benefit from a clean. I gathered the stuff I thought I might need, but all I used was the 3-IN-ONE degreaser foam, the Hammerite Rust Removal Gel, the green scouring pad, kitchen roll, and wet and dry paper (more than you see in the picture below). I start by spraying the plate with the degreaser. I have found that the rust remover works better on the first application if the surface has been degreased first. ...

Read this entry »


Part 3: Restoring the Saw Handle

11-13-2011 10:44 PM by Brit | 13 comments »

Did you know that saw handle making was a profession in its own right in the 19th century? Young men underwent an apprenticeship lasting 12 months before they could call themselves a saw handle maker. It seems a long time doesn’t it? One year, just to learn how to make a saw handle. However there was quite a lot of detailing to do on a 19th century saw handle. Some features were purely for decoration, whilst others had a distinct function. The handles in the following photograph from two o...

Read this entry »


Part 4: The Finale

12-12-2011 06:22 AM by Brit | 12 comments »

THE FINALE Repairing the Lamb’s TongueSo in my last post I’d fixed the large chip below the bottom saw nut. Now it was time to fix the chip on the lambs tongue. I started by paring the chipped surface flat with a chisel, then I ripped a section from an off-cut of beech dowel. Before gluing it onto the handle, I slid a hotel card key into the kerf where the saw plate goes. This served two purposes. Firstly, it ensured that I didn’t get excess squeeze out in the kerf whic...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase