Yes, it’s a karate practice dummy that I made for a friend at work. Definitely the most unique project I’ve done to date. Most of it was done with vintage hand tools using techniques I’d learned from nearly 20 years of watching Roy Underhill.
The body started out as a white ash log from a tree that came down about 4 years ago. After getting it into the shop, I started chopping away with a variety of hand tools including an adze, broad hatchet, firmer chisels, and anything else I could find that was sharp. I finally cheated a bit with a handheld power planer and, a few drive belts later, had worked it down to the desired 9” diameter.
After establishing a centerline, I laid out the 1 1/2” square mortises for the arms and leg, got my cordless drill (a.k.a. brace and bit) and wasted out most of the wood. Squared it up with a chisel. Did the same for the through mortises for the two rails. Seems like it should take more than three sentences to explain cutting those mortises given the amount of time that it took….
The framework is made of Honey Locust because 1) it was cheap, and 2) it’s very durable. The uprights attach to the base with a through mortise and tenon, and the two rails are attached with wedges through exposed tenons.
The leg exits the dummy at a 15 deg angle and has a large mortise & tenon joint at the knee. It’s about 3” square with rounded corners.
The arms and legs are held in place with wedges through mortises as shown in the last photo. The wedges give it a bit of an Asian look.
All in all, a pretty challenging project given all the handwork and joinery. While I am by no means a Karate expert (I didn’t even know there was such a thing as a practice dummy until I was asked to build one), I’m told that this type of dummy is for Chinese style training.

Started off making the candle holder in Woodsmith 173 for my wife. When I went to my local sawmill, I found a piece of spalted curly maple, and the project took on a life of it’s own from there. Made primarily using hand tools. Finished with multiple coats of tung oil.

This is a pantry cabinet I made for a relative who was short on cabinet space in the house she was renting. The upper cabinet is from plans in Workbench magazine and the base is home-grown. It’s made such that the cabinet can be wall-hung and the base can be used as a dresser if needed. Solid brass accents. Finished with General Finishes Mahogany stain and wipe-on polyurethane. At the time I took the photos, I was short one drawer pull.
My first foray into arch top raised panel doors. Learned a lot making this project!