Using a router to make the "Lazy Larry" #1: Making the "Lazy Larry" using a router and router jig.
Degoose showed us how to make the jig that uses a bandsaw to make the spiral sections of his “Lazy Larry”. Well I made the jig, but my old small bandsaw just wasn’t up to the task. I wasn’t about to quit, so I decided to try to make a jig that I could use with my router. It took me awhile to figure it out (using Sketchup), but once I did, it was rather easy to make the jig. Here is how to make the jig. Picture 1. 1. Cut a 3/4” thick piece of MDF or Plywood, 10” X 15”.2. Draw a line down the middle of the board as shown in the drawing.3. Draw a short line 1” from the edge of the board. This line must cross the first line.4...


















