LumberJocks

Spinning wheel #2: Tension screw in place

  • Advertise with us
Blog entry by Alongiron posted 08-10-2016 01:34 AM 583 reads 0 times favorited 3 comments Add to Favorites Watch
« Part 1: Let the head scratching begin!! Part 2 of Spinning wheel series Part 3: Turning the Mother of all »

After some hard work and careful measuring, the carrier pin is in place and the tension screws working properly. After turning the screw and pin, I was able to use my 7/8” tap and die to complete these parts and set them in place. I made the carrier pin from Oak because of the wear and tear it will take. All other parts have been turned from cherry. Next step is to complete the large wheel

-- Measure twice and cut once.....sneak up on it! Steve Lien



3 comments so far

View andy_P's profile

andy_P

398 posts in 2839 days


#1 posted 08-10-2016 06:16 PM

WOW!!!!!

-- Wood is a gift from God/Nature that maintains its beauty forever via the hand of a woodworker.

View AandCstyle's profile

AandCstyle

2716 posts in 1888 days


#2 posted 08-10-2016 08:20 PM

Steve, this might just be your crowning glory in terms of project difficulty. I wouldn’t even know where to start. Good luck!

-- Art

View Jim Jakosh's profile

Jim Jakosh

18163 posts in 2737 days


#3 posted 08-11-2016 05:00 PM

Wow, that looks like a real involved project. I don’t know if I’d tackle it. Good start on it Steve!!

Jim

-- Jim Jakosh.....Practical Wood Products...........Learn something new every day!! Variety is the Spice of Life!!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com